yagasra.blogg.se

1. #Error a supported tablet was not found on the system how to
2. #Error a supported tablet was not found on the system update
3. #Error a supported tablet was not found on the system windows

Step 2: Press and hold the power button for at least 20 seconds.

Step 1: Power off your computer and unplug the AC adapter cable.

#Error a supported tablet was not found on the system how to

Here is how to hard reset the HP computer. The second method is to hard reset your computer, which will reset all the configurations on your BIOS (apart from passwords) and allow the new configurations operating system changes and hardware changes on the next boot. Then you can check if the “selected boot image did not authenticate” error has been fixed. The computer automatically reboots to Windows. Step 6: Press F10 to accept the changes and select Yes and press Enter. Step 5: Then select Secure Boot and press Enter, then select disabled and press Enter. Tip: If it is disabled, you should select Enabled and press Enter. Step 4: With the down arrow key, select Legacy Support and press the Enter button. Step 3: Choose the System Configuration menu with the right arrow key, then select the Boot Option and press Enter.

Step 2: Press F10 to open the BIOS Setup when the Startup menu displays.

#Error a supported tablet was not found on the system windows

Step 1: You should enter the BIOS, read this post - How to Enter BIOS Windows 10/8/7 (HP/Asus/Dell/Lenovo, any PC). If you are sure that your computer cannot complete the start because of the virus or malware attack, then you can’t use this method use method 3 instead. You should change from Secure Boot to legacy boot in your BIOS settings. How to Fix the “Selected Boot Image Did Not Authenticate” Error Method 1: Change from Secure Boot to Legacy Boot in Your BIOS Settings Upgrade/changes on the operating system (which changes the boot loader information). Changes can happen due to the installation of new devices,Ĥ.

#Error a supported tablet was not found on the system update

The boot image can become corrupt after an update or due to a malware attack.ģ. This error occurs if your computer changes the boot order.Ģ. Here are three reasons for the “selected boot image did not authenticate” error.ġ. This error can also mean that your boot loader information is missing, therefore, the operating system could not be loaded. This error means that the security protocol was violated after checking the firmware database or the device from which the operating system was loaded could not provide the information needed for security to boot. You can go to MiniTool to get the methods to fix it. But sometimes, the “selected boot image did not authenticate.” error will occur. Hewlett Packard (HP) is one of the best computers, and like any other computer, it has a BIOS that loads devices and the system after checking for errors.